For example: To replace the 1-cylinder to 2-cylinder injector, just select the numbers “1” and “2”. After the injector correction code has been entered, select “Apply” to proceed according to the procedure prompt until you see the message that the new correction code was successfully sent to the ECM.Īfter setting the injector barcode, enter “Advanced ECM Data”-“Injector Reset” Ĭlick to select the cylinder number of the replaced fuel injector. In the “New Barcode” field, enter the injector correction code for the corresponding cylinder. Select “Advanced ECM Data” – “High Pressure Common Rail Injector Settings” – “New Bar Code” These Cummins trouble codes pertain to both models equipped with the High Pressure Common Rail (HPCR) fuel system. Here are all the ISL and ISC codes available for the Cummins ECM. Stop the engine and connect INSITE service software to ECM A complete list of all fault codes for Cummins engines with the HPCR fuel system. 0002 Exhaust Gas Pressure Sensor Number 1. 0001 Exhaust Gas Pressure Sensor Number 1 Circuit - Voltage Above Normal, or Shorted to High Source. After the INSITE software opens, click on Connect to ECM. Here are all the ISL and ISC codes available for the Cummins ECM. Turn on the vehicle and turn the key to the ON position. Open the INLINE connector located on the front of the passenger seat, connect INLINE (note the connection direction), and connect the other end of the INLINE to the computer.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |